Hey Guys!
I've been looking for designs for building my own Biltong box for a while now, and it's proving very difficult.
It seems that people just don't want to share their designs, and if they do,the instructions are never detailed enough to make one from scratch!!!
Well I went and did it and I'd like to share my ideas with you. If you have any comments or alternative idea's please use the comment box below.
I'm learning through progress so i won't take it to heart.
Here's what you'll need:
2x sheets 20mm thick MDF or plywood. (at least 1000mmx1200mm, this will give you some off cuts if/when you need them).
8mm Dowelling (1m)
Light fitting with working bulb. (access to a power source is essential)
Hand Held drill with Hole Saw Cutter (approx, 40mm)
Tight knit wire mesh (1mx1m)
Table-top electric saw, with wood attachment blade.
1x Set of Hinges
1x magnetic attachment clip
Some Masking tape, wood glue and wood screws are also helpful.
Most of this stuff you'll find around the house so the cost should be kept low!
